IPC Moisture Sensitivity Classification for Non-IC Components. Content Provider Association Connecting Electronics Industries [IPC]. IPC, PWB Assembly Sol- dering Process Guideline for. Electronic Components. • IPC, Moisture Sensitiv- ity Classification for Non-IC. Components. and Use of Moisture/Reflow Sensitive Surface Mount Devices). This standard supersedes IPC Developed by ECA, IPC and JEDEC.
|Published (Last):||11 November 2005|
|PDF File Size:||20.79 Mb|
|ePub File Size:||20.16 Mb|
|Price:||Free* [*Free Regsitration Required]|
This code shall only be used on product provided by through Integrated Supplier Partnering Agreements. If there are any questions contact Microwave Manufacturing Engineering.
The carrier shall be of a construction to allow component removal without tooling. Use of newsprint, excelsior, or loosed fill expanded polystyrene is not allowed as a means of cushioning. Moisture content prior to packaging shall not exceed 0.
Each moisture barrier bag shall be marked with the part number, date code, quantity, and serial numbers of the PWBs enclosed. Matte finish waffle packs should be used if available. A carrier that holds multiple components in a row. Tape and Reel Only General 9053 Suppliers should attempt to provide a best fit solution without incurring extensive tooling costs.
Once a Tray is chosen all components of that size for the entire P. Additional information on this requirement can be found at the following site: All the components shall be oriented in the same direction according to polarity or pin one markings. Items which are ESD sensitive shall be individually, electrostatically protected kpc appropriate industrial practices.
Orders over pieces must be supplied on a minimum of two 2 reels or minimum reel package quantity. Gel Trays must be labeled on the cover and the bottom of the base with the supplier lot number and part number, PO number and BAE part number. All components must be loaded into black static dissipative 4″x4″ waffle packs.
Specific packaging requirements will be provided by the using factory through the supplier electronic replenishment process. Individual Comp Carrier General Requirements: Parts must be loaded consecutively from left to right, proceeding from top to bottom as viewed with the notch of the waffle pack positioned in the upper left hand corner with a consistent separation between rows and columns.
Packaging Requirement Codes
All components must be loaded into black static dissipative 2″x2″ vacuum ipx trays. Do not handle with bare hands; use clean, lint free cotton gloves when handling. Components will be covered with a lint free filter paper insert s between the top of the component and the bottom of the cover. Parts do not have to be pre-oriented, but must be face up. Once a Wafflepack is chosen all components of that size for the entire P. Waffle pack capacity should be maximized within a manufacturing lot.
Preferred cavity depth should not exceed more than 20 mils above the top of the component. Static generating materials should be avoided.
Solid board packaging is ideal for achieving exclusive. Use of any static generating material is strictly prohibited. Special Packaging Package parts per instructions specified by purchase order or subcontracts, i.
Items that are ESD sensitive shall be individually, electrostatically protected using appropriate industrial practices. Parts should 953 pre-oriented, but must be face up.
A rigid container that holds one leaded component.
Minimum cavity depth is the same height as that opc the component. Moisture content may be assured by documented process controls or appropriate testing.
Packaging Requirement Codes
Best Commercial Practice Packaging of parts shall be sufficient to afford protection against deterioration and physical damage during shipment from the supply source to BAE Systems. All components must be loaded into black static dissipative 2″x2″ waffle packs. Matrix Tray 903 Requirements: The packaging shall allow the polarity or part number markings to be visible for each device.
Tubes Only General Requirements: Tubes for Surface-Mounted Components Definition: