Example Cisco MDS Switch Default Port License Configuration. switch# show port-license Available port activation licenses are 0. Cisco MDS Family Quick Configuration Guide. OL Using the Switch Setup Utility Verifying the Module Status CHAPTER. 3. Configuring. Note If a Cisco MDS or switch is used as a core switch, only a nontrunking F PortChannel is supported. Trunking is not supported on.
|Published (Last):||22 February 2013|
|PDF File Size:||8.58 Mb|
|ePub File Size:||4.33 Mb|
|Price:||Free* [*Free Regsitration Required]|
You can nondisruptively reconfigure the fcdomain by changing the configured domains on the overlapping links and getting rid of the domain overlap. Proudly powered by WordPress.
If you enabled the autoreconfigure option on both switches before connecting the fabric, a disruptive reconfiguration RCF will occur. From time to time I will blog about other things of interest. If a domain is currently isolated due to domain overlap, and you later enable the autoreconfigure option on both switches, the fabric continues to be isolated. If you assign port number for physical portshow can you assign for ports ?
Unofficial Cisco MDS Release 3.x CLI Config Guide Errata
This page incorrectly states that you can disable password verification with aaa authentication login none command. Page Document states: The autoreconfigure option takes immediate effect at runtime. About System Message Logging properly configured system message logging server. Page Figure shows incorrect ip default-gateway Page States in one bullet: This is not correct as this does not work.
Then states two bullets later: This is very redundant and can be combined into one bullet. Previous blog entries also dealt with storage, compute, virtualization and professional services. On the same page I find this block of text very vague and confusing: This is not correct. You do not need to restart the fcdomain. Should be 8 base ports, which can goto 8 or 16 additional ports. It is worded as if it is a requirement but it is in fact not. There is no information contained in the example given that shows the configuration or enabling of FCIP interfaces.
This situation can require several configuration tasks for each iSCSI host. IP routing does not have to be enabled, unless there is a specific topology where IP routing is necessary. FCIP uses different ports. Leave a Reply Cancel reply You must be logged in to post a comment.
Unofficial Cisco MDS Release 3.x CLI Config Guide Errata – Maximum Entropy
Certainly there is either a mistake in the wording or the example. Testing indicates that this is in fact enabled by default.
A disruptive reconfiguration may affect data traffic. This page incorrect states that fcns reject-duplicate-pwwn is disabled by default. This can mean several configuration tasks for each iSCSI host. This should be made more clear.
Have a few different people read that and I think you will see where I am coming from.
Although it can be configured it has no effect. You must be logged in to post a comment. This is not true. If you do not need gjide LUN access control, using the proxy initiator mode simplifies the configuration. Obviously there was a part of this paragraph that got chopped off somewhere. This blog is mostly about my pursuits in Data Science. I am not sure.
Page shows with 8 base ports 8 licensed for growth. These pages talk about an active mode of fcanalyzer. I am not sure that the statement in bold is correct.
Caution The span drop-threshold can be changed only if no span sessions are currently active on the switch.
The default authentication port is I am not sure if this is valid. When mdd join two switches belonging to two different stable fabrics that have overlapping domains, the following cases apply: I think what is meant here is: Reconfiguration as in changing of domains is always disruptive.
In this case, using the proxy initiator mode simplifies the configuration. Cisco Documentation team has internally re-written this as: