ASTM E2835-11 PDF

Published by on April 1, 2021
Categories: Spiritual

Calibration of Light Weight Deflectometers according to ASTM E and TP BF StB Part B, Service and repair. High quality equipments by TERRATEST!. DOI: / E–11 2 For referenced ASTM standards, visit the ASTM website, , or contact ASTM Customer Service at [email protected] Scope. This test method applies to measuring plate deflections using a Portable Impulse Plate Load Test device. The method covers the.

Author: Faekasa Vozuru
Country: Portugal
Language: English (Spanish)
Genre: Automotive
Published (Last): 8 February 2004
Pages: 40
PDF File Size: 20.85 Mb
ePub File Size: 14.12 Mb
ISBN: 508-4-52100-598-5
Downloads: 48614
Price: Free* [*Free Regsitration Required]
Uploader: Gabar

Therefore, care must be taken when analyzing the results because the data obtained by the Portable Impulse Plate Load Test may be obtained under substantially different conditions than when a heavy moving wheel load passes over the pavement surface after construction is complete.

ASTM E Light Weight Deflectometer Calibration | TERRATEST

The deflection is measured at the center of the top of the load plate see Note 1. The video demonstrates the most commonly used method of the Some uses of the data include quality control and quality assurance of compacted layers, and for structural evaluation of load carrying capacity see Note 2 and Guide. Proctor Test, Method A It is the responsibility of the user astk this standard to establish appropriate safety and health practices and determine the applicability e235-11 regulatory limitations prior to use.

  LIBRO MERIAM ESTATICA PDF

The values given in parentheses are for information only. This video demonstrates the moisture-density relations of soils test also called the Proctor Test. E2835-111 results are used for pavement Historical Version s – view previous versions of standard.

Pavetesting Falling Weight Deflectometer to measure the vertical deflection response of a surface to an impulse load, to determine surface material strength or For the last 40 years, Dynatest has been the frontrunner in structural pavement evaluation with its state asttm the axtm FWD Falling Weight Deflectometer. The LWD uses a load cell and geophones with the same accuracy as the Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard.

Accordingly, the test surface shall be as clean and smooth as possible with loose granules and protruding material removed. And the method was Annimated overview for the Dynatest LWD.

Light Falling Weight Tester by ASTM E

Falling weight deflectometer test fwd The portable impulse plate load test device ZFG 3. Stanlay Falling Weight E2835-111 The Static Plate Load Test applies in earthworks and foundation engineering as well as road construction in order to determine load settlement lines and by this See how fast and easy you’ll measure the compaction of soils in road Test the compaction quickly, precisely and cost-efficiently on site.

  CLASE GASTROPODA PDF

For gravel surfaces it is recommended that a thin layer of fine sand be placed over the test point. For fine-grained materials, this will help in obtaining a reasonably uniform contact between the load plate and the surface.

Link to Active This link will always route to the current Active version of the standard.

This video shows how easy to move the Zorn Instruments ZFG Light Weight Deflectometer in order to perform testing for deflection and dynamic modulus for The method covers the measurement of deflection of the load plate rather than the deflection of the surface of the pavement or foundation layers see Note 1.

The volume of the pavement foundation materials affected by the applied load is a function of the magnitude of the load, plate size and rigidity, loading rate, buffer stiffness, and the stiffness and shear aatm of the pavement foundation adtm.