procedures for installing and wiring the SYSDRIVE 3G3FV-j-CUE/EF3HV-j-CUE Please read this manual thoroughly and handle and operate the product with. The SYSDRIVE 3G3FV is OMRON’s new special-purpose inverter. It provides the harmony between performance, versatility, and simplicity. Using a unique. Manuals and User Guides for Omron SYSDRIVE 3G3FV. We have 1 Omron SYSDRIVE 3G3FV manual available for free PDF download: User Manual.
|Published (Last):||13 July 2011|
|PDF File Size:||5.39 Mb|
|ePub File Size:||19.33 Mb|
|Price:||Free* [*Free Regsitration Required]|
Be sure to remove the short bar before connecting a DC reactor.
OMRON SYSDRIVE 3G3FV Series Inverters
Chapter 2 Installation H Protecting Inverter from Foreign Matter During Installation Place a cover over the Inverter during installation to shield it from metal power produced by drilling. Stops faster than free-run, without regenerative operation.
Auto-tuning is the only setting for basic operation with open-loop vector control. In this case, the actual speed limit value is the sum of the voltage input value at terminal 13 and the current input value at terminal Decelerates to a Fault stop according to the C setting. Page Chapter 6 Advanced Operation When this parameter is set to 3, in contrast to a setting of 0, the deceleration time is automatically prolonged with main axis overvoltage OV easily detected. Displays the input voltage setting display.
Terminal Parameter Lists Applies initial excitation when flux vector control is being used. Chapter 6 Advanced Operation Note 1. Internal frequency reference d Set 3v3fv reference d d d H Hold Reference Memory Selection d Parameter d selects whether the held frequency during motor operated potentiometer MOP sim- ulation operation is stored when operation is stopped.
OMRON SYSDRIVE 3G3FV USER MANUAL Pdf Download.
The acceleration time and deceleration time are too short. Lit when there is a reverse command input. Press the Menu Key to display the operation mode, and enter the drive mode by pressing the Enter Key.
Got it, continue to print. Wire thickness Model Manufacturer 0.
OMRON SYSDRIVE 3G3FV – In Stock, We Buy Sell Repair, Price Quote
Table of contents General Precautions Chapter 6 Advanced Operation falls below the excitation level ba position control loop is formed and the motor is stopped. Page Chapter 5 Basic Operation The parameter settings which are used most often are explained below.
Displays the rated voltage.
After initialization the access level is set to Quick-start A Valid access levels Parameter Display name Setting Standard fan-cooled motor 0 to If the contents of the fault majual dis- played, refer to Protective and Diagnostic Functions.
Sets the motor rated voltage. If responsiveness is low, lower the set value. Comments to this Manuals Your Name.
Page The voltage fluctuations in the input power supply are too large.
Should you find any problems with the product, immediately contact your nearest local sales representative. Motor starts from minimum output frequency. The parameter settings described here will be sufficient for simple Inverter operations.
The table shows the default setting for V class, 0. Speed search is performed from maximum output manua, and motor is started.
Chapter 6 Advanced Operation Selecting Auto-tuning Carrier Frequency The auto-tuning carrier frequency is by default set to a value higher than that used for conventional models to improve the accuracy of auto-tuning. Chapter 6 Advanced Operation When a shock is generated at startup, increase manusl setting for the starting-torque compensation time constant C Chapter 1 Introduction The 3G3FV allows the following three kinds of access levels to be set in janual to further simplify pa- rameter setting.
Set values 0 to 3. Chapter 5 Basic Operation Note 1. Table of Contents Common Functions Chapter 8 Maintenance Operations A signal is being input to the frequency reference current terminal These function groups are known as modes.